Over-Moulded Products


more detailenlarge

These parts were moulded in our twin barrel Arburg over-moulding machine. A pre-form and a finished product are produced each cycle of the machine. Mechanical and chemical bonding are required to ensure perfect bonding between TRP and alloy resin.

Material selection is important and is chosen in collaboration with local agents and their overseas principals.

 Two Stage Over-Moulding
more detailenlarge

Low volume over-moulding, plastic on plastic, is usually done in two stages from two tools.

Brass inserts or threaded stainless steel shanks are over moulded in one operation.
Electronic Housings
more detailenlarge

The surface finish, clipping mechanism, and printing were the main critical requirements of these mouldings.

(The bezel has been painted silver).